Lets see some full size pictures...

b9ev

Adventurer
I had written a post with 2 pictures and tried to edit to add the above photo and it got deleted. Anyhow, the Toyo RTs worked great on snowpack and ice and worked well in about 4" of snow. If we hadn't gotten stuck in traffic for 3 hours we would have gotten to about 18" of snow to drive in.



 

Bella PSD

Explorer


Truck and engine:
02 Super Duty CC Lariat 4x4 (REAL floor shifter W/lock out hubs), 7.3L Diesel, ZF 6 SPEED w/LUK clutch & South Bend Kevlar PB, DP Tuner- Stock HP,40HP,60HP,80HP,120HP,140HP, 1.15 A/R NON Wastgated Van TURBO with ATS housing, and Non-EBV Turbo Pedestal, ITP Over boost Pressure Regulator, Crank Case Vent mod, 4" DPPI down pipe, 4" custom mid side exit straight pipe (before the rear tire), Tymar open intake, Dana 60, 3.73 gearing LS,
Exterior:
IH T 444E BADGES, 06 red Grill, Ranch hand bumpers front and rear W/skid plate, 3 step N-Fab side bars, 06 heated TT mirrors, Mastercraft 35" MUD tires on Helo Maxx 16x10 BLACK RIMS, Superlift 5" LIFT, ARE Z Cap with 4'x5'x6" Con Ferr Roof Rack, 35" spare roof top mounted, Bushwacker Fender Flares
Interior:
Auxiliary Idle Controller, Excursion center console w/Wood & Rear Radio Controls, Triple A-pillar Gauges, Rhino Lined light gray(not black), Garmin GPS 12map, Uniden CB, Husky floor liners (custom cut for 6 speed), Wet Okole Waterproof Neoprene seat cover rear and Smittybilt G.E.A.R. seat covers front, Norcold 60L fridge
Dyno:
320 RWHP and 700 RWTQ with 35" tires before new turbo
MPG
17-22MPG depending on load

Louie!
I just looked and my post in this thread and it was in 2008 on page 4 of 472 pages. Thought I would update as the truck changed a little. The truck might change again soon to a aluminum flat bed with drop down sides. A platform for a custom flatbed camper. I already have the flatbed ready to go on.
X

 
Last edited:

tyler.96

Observer
Been a while since I've seen you on here! Love your truck! Did you ever end up installing lights on the back of the topper?
I just looked and my post in this thread and it was in 2008 on page 4 of 472 pages. Thought I would update as the truck changed a little. The truck might change again soon to a aluminum flat bed with drop down sides. A platform for a custom flatbed camper. I already have the flatbed ready to go on.
X

 
Top