Inyo_man
Don't piss down my back and tell me it's raining.
Replaced both forward motor mounts...
At first glance the mounts appeared worn, but didn't look too bad.
Upon closer inspection there was a small crack in the rubber that looked to go around the mount- although it's difficult to inspect the mount from all angles.
Jacked up the motor using some blocks of wood and a bottle jack after putting the rig on jack stands to take the weight off the front mounts.
Removed the upper and lower nuts/bolts.
Jacked up the motor until it was almost touching the firewall.
Removed the old, broken mounts.
Installed new mounts. (The new mounts were a tight fit.)
Both front mounts were broken completely in half!
Ready to roll!
At first glance the mounts appeared worn, but didn't look too bad.
Upon closer inspection there was a small crack in the rubber that looked to go around the mount- although it's difficult to inspect the mount from all angles.
Jacked up the motor using some blocks of wood and a bottle jack after putting the rig on jack stands to take the weight off the front mounts.
Removed the upper and lower nuts/bolts.
Jacked up the motor until it was almost touching the firewall.
Removed the old, broken mounts.
Installed new mounts. (The new mounts were a tight fit.)
Both front mounts were broken completely in half!
Ready to roll!
Attachments
Last edited: