Weatherproof grommet for multiple comms wires entering side of vehicle? What's the go-to?

[irish44j]

My antenna wiring (GMRS, CB, AM/FM) is going to enter via a side panel (rear quater rear next to my tailgate hinges). Is there a preferred/go-to weatherproof grommet/seal that people like? I'll have a drip loop down and then the wire will come "up" to the hole, so something that curves downward to prevent water entry in rain is probably preferred. Needs to be large enough to pass the connectors through, obviously. Any recommendations? i was thinking of just checking a boat supply place but if there's something else that's better, LMK!

 

[billiebob]

Amazon is your best source.

These are my favourite.

ZILONG Black Nylon Waterproof Adjustable 3.5-13mm Cable Glands Joints, PG7, PG9, PG11, PG13.5, PG16, Pack of 20, Conduit Fittings - Amazon Canada

ZILONG Black Nylon Waterproof Adjustable 3.5-13mm Cable Glands Joints, PG7, PG9, PG11, PG13.5, PG16, Pack of 20 in Conduit Fittings.

www.amazon.ca

 

[irish44j]

Yeah, was kind of hoping for something that I can pass all three through rather than drill three separate holes, to be honest. Gland joints are obiously the easy (if not as attractive) way!

 

[craig333]

If you don't want to remove the connector https://www.westmarine.com/buy/blue...-44-11-18mm-max-cable-dia--540732?recordNum=4

 

[irish44j]

Cool, I have those on my boat now that I think of it, never even thought about it!

 

[irish44j]

Just to follow up on this, I ended up using the Cable Clam and it works great!