UJOR Build Thread
- Thread starter ujoint
- Start date
another_mike
Adventurer
I just spent an entire day doing it. No plasma cutter available unfortunately. I used an angle grinder, cutting wheel and air hammer. Then had to cut two ears off once it was loose to get it out. It wasn’t fun.
Don’t know if the diesels have charcoal canisters for the evap system, but I have to figure out how to mount that now too. That isn’t a small system either lol
225
Village Idiot
I have a 7.3 and there’s no evap system back there. I don’t have a plasma either, so it looks like grinder and air hammer for me too.
Sent from my Faptop 5000 using Tapatalk.
ujoint
Supporting Sponsor
1st few coil revision kits are shipping! Everything in the pic is included (plus a tie rod spacer/sleeve) to convert and Ujoint or MG coil conversion to crossover steering with a relocated trac bar. This kit won't work to retrofit any other 4x4 conversion, has to be the UJ or MG setup. The only thing that needs to be modified on the existing brackets is to open the upper trac bar hole to 7/8. The new lower trac bar mount is weld on and we recommend to weld the upper mount to the frame for added strength. We're working hard to collect steering knuckles, have quite a few 05-12s and gathering 13/ups. Had to revise the machining process for them (knuckle in the pic is a 13/up) because a lot of guys have these axles for the bigger brakes. Let me know if you have any questions, we're fixing vans and shipping these kits as quick as we can!
sakurama
Adventurer
1st few coil revision kits are shipping! Everything in the pic is included (plus a tie rod spacer/sleeve) to convert and Ujoint or MG coil conversion to crossover steering with a relocated trac bar. This kit won't work to retrofit any other 4x4 conversion, has to be the UJ or MG setup. The only thing that needs to be modified on the existing brackets is to open the upper trac bar hole to 7/8. The new lower trac bar mount is weld on and we recommend to weld the upper mount to the frame for added strength. We're working hard to collect steering knuckles, have quite a few 05-12s and gathering 13/ups. Had to revise the machining process for them (knuckle in the pic is a 13/up) because a lot of guys have these axles for the bigger brakes. Let me know if you have any questions, we're fixing vans and shipping these kits as quick as we can!
Thanks for shipping this before your vacation Chris! I'm looking forward to getting this on the van and I'll detail the install in my thread.
Gregor
ujoint
Supporting Sponsor
No prob! I sent a few stock pitman arms for you guys, will need to ID yours once the reamed arm is off. Let me know if you need any guidance during the swap.
Is this because the newer vans come with the RSC package??