*sale pending 8-8-21* Chevy Colorado 2019 Overland build w/AT Summit Camper, Goose Gear, etc. V6 4x4

***sold on 8-9-21***

Overland built Colorado, well maintained with all service records. I am entertaining all serious offers, asking $37,000. Read on…

Old Man Emu upgraded suspension added by Summit 4x4 in Prescott AZ and BF Goodrich K02 tires.

AT Overland Summit Topper installed by AT Overland in Prescott AZ, has a mattress up top that sleeps 2.
EZ-awn batwing awning added by AT Overland in Prescott AZ.

Rotopax fuel and water on the sides

Goose Gear drawer system, also added by AT Overland. total of four slide out drawers and two top load. One of the drawers is a little stiff on the slide out but has been since I picked it up.

Snorkel added by AEV in Wixom, MI.

ARB Bumper and Warn Winch added by Love your Car and Truck in Traverse City, MI.

All upgrades have been done by professionals, so no back yard work or sub-standard work done by someone with no skills (me) lol

Vehicle has about 34,000 and has had religious maintenance with oil changes and tire rotations, etc.

Check out the individual cost and labor of all the items I have added and see if you think this is a good value. I have roughly $65k in this truck, and it has served me very well, but my wife and I just decided to try van life for a while. If you are unfamiliar, check out AT Overland, Goose Gear, Summit 4x4, etc. so you can see the pros that have done the work.

The rear swing gate in the photos I will throw in also, it is a RIGd ultra swing, with a camp table, including the hi-lift jack, and Aluminess shovel and ax.

The Rotopax locks are a little rusted and sometimes stick, so that is one thing that is wrong.

There is a small chip in the windshield, smaller than the head of a q-tip.

I honestly cannot think of anything else wrong with the truck, I have kept it in great shape and have really enjoyed it, still enjoy it, but my loving wife is not going to allow four vehicles in the driveway for long - lol.

This is my first posting so hopefully I have followed all the rules and been open with all the needed info.

I will not be able to consider removing and selling the topper alone, as there are holes drilled in the bed to make the installation "permanent."

The truck is currently located about 45 miles south of Traverse City, MI.
 

Attachments

  • exterior camper up.JPG
    exterior camper up.JPG
    6.3 MB · Views: 397
  • Interior bed down.jpeg
    Interior bed down.jpeg
    2.6 MB · Views: 403
  • Interior.jpeg
    Interior.jpeg
    2.2 MB · Views: 355
  • Mileage.jpeg
    Mileage.jpeg
    1.4 MB · Views: 351
  • Ultra Swing with table.jpeg
    Ultra Swing with table.jpeg
    3.5 MB · Views: 371
  • drawers open 1.jpg
    drawers open 1.jpg
    3.2 MB · Views: 401
  • Exterior 2.jpeg
    Exterior 2.jpeg
    3.9 MB · Views: 422
  • 6349.jpeg
    6349.jpeg
    4.8 MB · Views: 408
  • 7806 - Copy.jpeg
    7806 - Copy.jpeg
    5.2 MB · Views: 363
Last edited:

FAW3

Adventurer
Can you please provide the measurement of the open floor area? Specifically the distance 1: between the Goose cabinets; 2: front bulkhead to rear tailgate; 3: floor to the lower edge of the topper (ie: maximum height of an object able to be loaded via tailgate).
 
Can you please provide the measurement of the open floor area? Specifically the distance 1: between the Goose cabinets; 2: front bulkhead to rear tailgate; 3: floor to the lower edge of the topper (ie: maximum height of an object able to be loaded via tailgate).

  • 28 inches between the Goose Gear drawers
  • interior bed length is 60.5 inches
  • interior height, to safely slide something in is 40 inches because the back hatch of the Summit Camper door is a few inches lower than the bottom of the sleeping platform. From the bottom of the sleeping platform to the truck bed is around 43 inches.
 
Anyone know how I "bump to the top" because I have seen others do that and I have no idea how to do that - lol. Open to offers here.
 
Thanks to all the messages so far, posting a thank you here in case I missed any. I believe I have replied to all the personal inquiries - still kind of new at this.
 

Reido15

New member
Is there an easier way to contact you? I’m in the Cadillac area on a regular basis and I’d like to come look at your truck and camper setup and see if it would work. Thanks.

I don't know how to delete an old post so I am re-listing now that I have made a few changes here.

Overland built Colorado, well maintained with all service records. I am entertaining all serious offers, asking $37,000. Read on…

Old Man Emu upgraded suspension added by Summit 4x4 in Prescott AZ and BF Goodrich K02 tires.

AT Overland Summit Topper installed by AT Overland in Prescott AZ, has a mattress up top that sleeps 2.
EZ-awn batwing awning added by AT Overland in Prescott AZ.

Rotopax fuel and water on the sides

Goose Gear drawer system, also added by AT Overland. total of four slide out drawers and two top load. One of the drawers is a little stiff on the slide out but has been since I picked it up.

Snorkel added by AEV in Wixom, MI.

ARB Bumper and Warn Winch added by Love your Car and Truck in Traverse City, MI.

All upgrades have been done by professionals, so no back yard work or sub-standard work done by someone with no skills (me) lol

Vehicle has about 34,000 and has had religious maintenance with oil changes and tire rotations, etc.

Check out the individual cost and labor of all the items I have added and see if you think this is a good value. I have roughly $65k in this truck, and it has served me very well, but my wife and I just decided to try van life for a while. If you are unfamiliar, check out AT Overland, Goose Gear, Summit 4x4, etc. so you can see the pros that have done the work.

The rear swing gate in the photos I will throw in also, it is a RIGd ultra swing, with a camp table, including the hi-lift jack, and Aluminess shovel and ax.

The Rotopax locks are a little rusted and sometimes stick, so that is one thing that is wrong.

There is a small chip in the windshield, smaller than the head of a q-tip.

I honestly cannot think of anything else wrong with the truck, I have kept it in great shape and have really enjoyed it, still enjoy it, but my loving wife is not going to allow four vehicles in the driveway for long - lol.

This is my first posting so hopefully I have followed all the rules and been open with all the needed info.

I will not be able to consider removing and selling the topper alone, as there are holes drilled in the bed to make the installation "permanent."

The truck is currently located about 45 miles south of Traverse City, MI.
 
Is there an easier way to contact you? I’m in the Cadillac area on a regular basis and I’d like to come look at your truck and camper setup and see if it would work. Thanks.

I am getting regular emails for people who are inquiring that are private, but I am unsure how to direct you to start a conversation in that way. I’d be happy to have you look at it.
 
Is there an easier way to contact you? I’m in the Cadillac area on a regular basis and I’d like to come look at your truck and camper setup and see if it would work. Thanks.

I found it, click my name / ID and it starts a private conversation.
 

Forum statistics

Threads
185,914
Messages
2,879,569
Members
225,497
Latest member
WonaWarrior
Top