pugslyyy
Expedition Vehicle Engineer Guy
Since I had to deconstruct my raw water system to get at the rear driver side leaf spring pin, I decided to change a few things. The tubing that it had been built out of was not rigid enough and collapsed during suction mode, so I wanted to redo it with something more rigid. I'm a big fan of PEX so decided to use that (and in this application it is protected from UV which is the big challenge for PEX)
Here's the layout of what I want to do -
And here is the first piece of it -
(I crimped a hose fitting temporarily on to the inlet to pressurize and check for leaks, if you are wondering.)
Here's the layout of what I want to do -
And here is the first piece of it -
(I crimped a hose fitting temporarily on to the inlet to pressurize and check for leaks, if you are wondering.)