jesusgatos
Explorer
I finished-up the last of the cabinets and all of the woodwork at Davis Cabinets last week, and now I'm working on the electrical and plumbing and all that fun stuff.
One of the things I need to do is design/build some type of insulated mount for my computer, which is going to sit in this cabinet (on the slide-out tray). I'm going to be living AND working out of this vehicle, so I wanted to make room for a fullsize tower.
Here's a picture to help everyone see what I'm working with:
So how would you guys tackle this? I was thinking about sandwiching the tower between two pieces of foam (top & bottom), like we do with radiators on off-road vehicles. I figured that I could make a little sheetmetal top-cap and then use something like tie-down straps to keep things tight. Any better ideas?
Here's a picture of a rig from the outside:
One of the things I need to do is design/build some type of insulated mount for my computer, which is going to sit in this cabinet (on the slide-out tray). I'm going to be living AND working out of this vehicle, so I wanted to make room for a fullsize tower.
Here's a picture to help everyone see what I'm working with:
So how would you guys tackle this? I was thinking about sandwiching the tower between two pieces of foam (top & bottom), like we do with radiators on off-road vehicles. I figured that I could make a little sheetmetal top-cap and then use something like tie-down straps to keep things tight. Any better ideas?
Here's a picture of a rig from the outside: