Jeep XJ Westfalia Camper Build - The "Jeepagon" V2

Recommended books for Overlanding

Sailing Alone Around the World: a Personal Account of the...
by Joshua Slocum
From $26
Vehicle-dependent Expedition Guide
by Tom Sheppard
From $100.75
The Essential Guide to Overland Travel in the United Stat...
by TeriAnn Wakeman
From $64.95
Long Way Down: An Epic Journey by Motorcycle from Scotlan...
by Ewan McGregor, Charley Boorman
From $15.96
Road Fever (Vintage Departures)
by Tim Cahill
From $12.99

jakegrovephoto

Active member




First top (post above), the vinyl ester didn’t kick as soon as the polyester I was used to.
Alligatored the Gelcoat from wet resin sitting on it too long and ruined the whole part, and the surface finish of the mold (again). Had to pull it as a throw away.

Since wetsanded the mold all again. 500 > 1000 > 1500 & Polishing Compound.

PVA went down much better with a different spray technique. Slight orange peel as is expected from PVA, but a nice solid film that made the part pop right out this second go around.

It’s been a long journey, to say the least.
 

jakegrovephoto

Active member
Maybe you could sell the throw away to someone who doesn’t care about looks/finish to recoup some of the cost?
It’s an idea. I was only one layer of glass in though, so it was yanked before any real bulk of materials was use. Used it to test fit for everything, but it already has holes and cracks just from pulling with that thin of glass.

Onward to the next chapter of this build
 

jakegrovephoto

Active member

I’ve turned into a Fiberglass Junky

LED Tail Light Housings are done.
JCR and other make some solid metal ones, but nothing I’ve seen follows the body line as well as these stock Cherokee “replicas”
 

Recommended books for Overlanding

National Geographic Road Atlas 2020: Adventure Edition [U...
by tional Geographic Maps
From $17.58
Adventure Motorcycling Handbook: A Route & Planning Guide
by Chris Scott
From $45.45
Road Fever (Vintage Departures)
by Tim Cahill
From $12.99
Top