I am not concerned that grinding I will be doing will alter the supporting of the cross on the DL as the stock cross is not supported in this area at the ends of the cross either.
Keith: I am positive the "C's" smaller opening is the only thing holding the DL from seating on the cross bores in the split case. If the each side of the case was 50/50 at the cross the DL would slip right in. But since its 60/40 is just gets held up at the opening of the "C".
Thanks
Jared
Keith: I am positive the "C's" smaller opening is the only thing holding the DL from seating on the cross bores in the split case. If the each side of the case was 50/50 at the cross the DL would slip right in. But since its 60/40 is just gets held up at the opening of the "C".
Thanks
Jared