Great Bones for a Build 1st gen Dodge Ram cab and chassis 4x4

windtraveler

Observer
Super Clean 1987 Dodge 3/4 ton 4x4 1st gen Dodge Ram. Regular cab & chassis. Great bones, no rust, minor dent passenger side cornerpost of the cab. 360 with NP 435 4spd manual transmission with PTO and 2-speed manual transfer case (and I believe 4.88 gears). Super stout truck. Was my plan to do a complete restore but too many other projects and the wife says I need to unload a few. So far I have installed a new clutch, pressure plate & throwout bearing, plugs, wires, rotor, distributor cap, intake manifold, carburetor, starter, valve cover gaskets, and oil pan gasket. No tail lights (I took off the service body and planned to put on a flatbed with installed lights. Runs but could stand to be tuned (I don't have a timing light). Odometer reads 02981 and based on the condition of the truck I believe it has only turned over once. Truck is located about an hour east of Portland, OR. $2500 OBO
 

Attachments

  • IMG_3939.jpg
    IMG_3939.jpg
    114.3 KB · Views: 183
  • IMG_3938.jpg
    IMG_3938.jpg
    123.7 KB · Views: 162
  • IMG_3937.jpg
    IMG_3937.jpg
    123.4 KB · Views: 892
  • IMG_3940.jpg
    IMG_3940.jpg
    139.6 KB · Views: 154
  • IMG_3942.jpg
    IMG_3942.jpg
    101.6 KB · Views: 147
  • IMG_3943.jpg
    IMG_3943.jpg
    119.5 KB · Views: 145
  • IMG_3944.jpg
    IMG_3944.jpg
    113.6 KB · Views: 219
  • IMG_3945.jpg
    IMG_3945.jpg
    81.2 KB · Views: 145
  • IMG_3946.jpg
    IMG_3946.jpg
    93.3 KB · Views: 195
  • IMG_3936.jpg
    IMG_3936.jpg
    123.1 KB · Views: 139

Forum statistics

Threads
185,830
Messages
2,878,680
Members
225,393
Latest member
jgrillz94
Top