Gen 3 Ball Joint Spacers

[Surf4luke]

Anybody using them with their lifts?
I just purchased a 45mm spacer kit and opted for the 15mm ball joint spacers.
I haven't found any discussion on it. Seems like you'd recover some front end flex with them.

 

[plh]

for a Gen 3? Thats a new one...

 

[Surf4luke]

I was going to try out this kit.
I was surprised to see the ball joint spacers
Amazon.com: Tema4x4 Complete Lift Kit 45mm for Mitsubishi PAJERO, MONTERO 3gen +ball joint spacers : Automotive

 

[plh]

I was going to try out this kit.
I was surprised to see the ball joint spacers
Amazon.com: Tema4x4 Complete Lift Kit 45mm for Mitsubishi PAJERO, MONTERO 3gen +ball joint spacers : Automotive

mall crawling

 

[Surf4luke]

I know.. ?
Shipping to AK is $5-600 for a proper suspension kit, for way less than shipping I thought I could experiment around with a spacer pack and pick up an Ironman/OME/LUSO the next time I'm in the lower 48.
Nobody has any thoughts on BJ spacers then?

 

[Toasty]

I'd really really advise against this on a Gen 3, as is their ball joints can tear away from the arm. They're not as reinforced as the Gen 2, I've seen it twice now so if you do install a spacer I'd have someone beef up the arm where the ball joint sits. Alternatively you can buy the Total Chaos arms and have all the gains but they're expensive.