P0335 crank position sensor circuit fault and P0340 cam position sensor circuit faults now after a timing belt job
its a 2003 3.8 Full size montero. idles perfect, no sign that the belt jumped a tooth. Been through the grounds and connectors and cant see anything. reading up says both together at the same time leads to a wiring issue or ground issue but I cant see anything.
Had to spend alot of effort degreasing and cleaning the engine as well as flushing the cooling system. I did have the intake off to replace the valve cover gasket as well. I kept the harness relatively dry and no oil in any of the plugs.
has anyone ever had this before? it comes on pretty quick then the tractio control and abs cut out too. both codes pop at the exact same time so im reasonably certain that the sensors are fine.
do the engine control modules swap without having to program? i can swap from my 2006 if so. shouldnt be much if any difference between them. enough to test.
I have the PDF manual but am having a hard time locating the harness location page, to try to find splice joint and connector locations.
needing some help. Thanks
its a 2003 3.8 Full size montero. idles perfect, no sign that the belt jumped a tooth. Been through the grounds and connectors and cant see anything. reading up says both together at the same time leads to a wiring issue or ground issue but I cant see anything.
Had to spend alot of effort degreasing and cleaning the engine as well as flushing the cooling system. I did have the intake off to replace the valve cover gasket as well. I kept the harness relatively dry and no oil in any of the plugs.
has anyone ever had this before? it comes on pretty quick then the tractio control and abs cut out too. both codes pop at the exact same time so im reasonably certain that the sensors are fine.
do the engine control modules swap without having to program? i can swap from my 2006 if so. shouldnt be much if any difference between them. enough to test.
I have the PDF manual but am having a hard time locating the harness location page, to try to find splice joint and connector locations.
needing some help. Thanks