DogCatcher
New member
I was changing the brakes on our 2014 Grand Cherokee and noticed that the front driver strut was leaking. One of the rear shocks had previously blown out as well. It was replaced under warranty, but at this point I just want to replace the factory stuff with some Bilteins since I've always had good luck with their products.
I noticed that in addition to the typical B6 4600 series, they also have a B8 5100 series. These have an adjustable snap ring that sets the hight of the spring perch, allowing for adjustment of the ride hight in a few predefined increments. I took a couple of measurements and it seems like the 1.25" setting would probably just about level the ride.
Has anyone here used these? If so, what setting leveled the ride height out?
I noticed that in addition to the typical B6 4600 series, they also have a B8 5100 series. These have an adjustable snap ring that sets the hight of the spring perch, allowing for adjustment of the ride hight in a few predefined increments. I took a couple of measurements and it seems like the 1.25" setting would probably just about level the ride.
Has anyone here used these? If so, what setting leveled the ride height out?