2004 Sequoia (Project Baby Panda) - Adventure and Build Page

toyotech

Expedition Leader
Operations rear fusebox. 4 awg wire was used. I will be piggybacking the terminal for future air compressor. Also got an inverter going into the drawer system.

I wanted to run as little wires on the exterior as possible. So near the battery (aftermarket circuit breaker) it runs down to the frame and back up just under the driver seat (near fuel door lever). Typical I just cut a hole in the rubber grommet but I wanted a cleaner finish. Went to the drawing board and drew up a OCD WGP (wire grommet plug) did a few versions and finally got one I like.

Fusebox will sit temporarily near the side cubby hole as I got future plans to cut it out for future projects. Than the fusebox will find it’s finally home than.
3beffd6d40fb0609f64be0890e53e384.jpg

cd5b2280d1807d6936f628e4b1bb45ff.jpg

181a3b84af44a00dfaa581a2d4e6763f.jpg

044fe004d4926deb0f9abf67caab0119.jpg

a06805a611ca76821eaad05275bbfb2a.jpg

1003dbacf47fa5b95739174aa4701897.jpg

987918de23455d96e03259b30ba7fe77.jpg

4a02d49f44ca4a7597d48f748878ae68.jpg



Sent from my iPhone using Tapatalk
 

busmup808

Member
Operations rear fusebox. 4 awg wire was used. I will be piggybacking the terminal for future air compressor. Also got an inverter going into the drawer system.

I wanted to run as little wires on the exterior as possible. So near the battery (aftermarket circuit breaker) it runs down to the frame and back up just under the driver seat (near fuel door lever). Typical I just cut a hole in the rubber grommet but I wanted a cleaner finish. Went to the drawing board and drew up a OCD WGP (wire grommet plug) did a few versions and finally got one I like.

Fusebox will sit temporarily near the side cubby hole as I got future plans to cut it out for future projects. Than the fusebox will find it’s finally home than.
3beffd6d40fb0609f64be0890e53e384.jpg

cd5b2280d1807d6936f628e4b1bb45ff.jpg

181a3b84af44a00dfaa581a2d4e6763f.jpg

044fe004d4926deb0f9abf67caab0119.jpg

a06805a611ca76821eaad05275bbfb2a.jpg

1003dbacf47fa5b95739174aa4701897.jpg

987918de23455d96e03259b30ba7fe77.jpg

4a02d49f44ca4a7597d48f748878ae68.jpg



Sent from my iPhone using Tapatalk

Did you make this in Solidworks? Also what type of 3D printer did you use? I’m using Prusa and Markforged in class. Nice work


Sent from my iPhone using Tapatalk
 

redthies

Renaissance Redneck
Suspension plans? After watching a bit of that video you posted it seems like it might be a good idea to add some clearance?
 

Forum statistics

Threads
185,527
Messages
2,875,534
Members
224,922
Latest member
Randy Towles
Top