Search results

Bought new, went a different direction with the build. Brand new in the box (opened once to look at it) $120 Located in Orange County https://www.napaonline.com/en/p/BK_MTSA2525?impressionRank=1

I have a 100AH lifepo4 battery that is charged by my jeep when I drive and when I'm parked for a few days I have a folding 160AH solar battery that keeps it topped off. For ice cream - put in one of the freezer inserts on the bottom. It's thin and when it gets really hot it might be an issue...

Love it. Had it on plenty trips with me. Taking it on another weeklong trip next week. While at home I use it to bring frozen groceries from the store. How did I pay for it? With a credit card :)

I have seen it last summer - it's in an amazing shape!

Nice! My wallet is hating your ideas ;)

Nice!!!!

potentially interested :)

How long did you have each jeep? I'm curious about long term cracking/wear and tear on the body side mount. When I get home I'll pop off the tail light and snake a cam in there to see what's there. I got an idea that might work out pretty nicely but don't want to screw things up

That's for TJ. I'm asking about a JK

Howdy! So I got some ideas but before I even test them out and put them into something tangible I'm curious if anyone has an idea as to the weight capacity of the JKU hinge mount. I currently have the morryde hinge and gate stiffener but I wonder about the body side. How much weight can it...

I used one of the light openings on my rear bumper to host the 7 pin connector. I just fabbed a plate that had the shape of the light.

Not sure if I mentioned this to you or the MOrryde folks, but many years back as a courtesy while having something else done Jeep replaced my stay rod under the TSB so I don't have the original one. I agree that the gap is the problem. I disagree about having to move the hinge around. The...

See attached

So it's .396. .021 out of spec. Not a lot, but still. Eyeballing it though I think even at .375 the spacer is too thick. Look at the gap that I have. What's frustrating is that I have sent the picture of the gap to them and indicated that even eyeballing it, the spacers look to thick based...

.43" +/- .01" - hard to measure without taking the hinge off

I'll say this: I sent pictures of how the spacer is too thick and misaligns the gate to the body. I provided a detailed description up above. Not sure what discussions still need to happen: a properly aligned hinge makes the gate sit flush is a good next step... Potential solution? Thinner...

So here's where I am at today. Morryde sent me replacement hinges thinking it's an issue with my hinges. I installed them and found that with the new hinges I still open close to 7 degrees past 90 degrees and the stay arm still pops out. The difference between my hinges and the new hinges is...

That's not a bad idea, but I wonder how much (knowing my luck) trouble I'm asking for by doing that. As a result the rod would be slamming against the other side of the mechanism.

Who should I reach out to? I'm currently working with Ryan. My biggest problem is that the stop is f-ed up as after reinsertion is making grinding/popping noises. Btw, while I partially agree with your statement about the 7 years, being quite a bit, there should be a note on the gate piece...

so I'm talking with folks from Morryde and here's my findings so far: 1. The rubber piece would do squat for me as for one rubber compresses and wears out and at time would allow for more and more travel 2. I took a protractor and the hinge allows for opening of 15degrees past 90 (total angle...