It's impossible to tell from the video I made if the shaft was loose on the original steering gear. I should have pulled the skid plates off and observed it from underneath as someone turned the wheel. Its very awkward to get to it from up top. You have to stand on a stepstool to get up there...
So after a few days driving with the new box it was sloppy again. I admitted defeat and scheduled a time to bring it into the pros.
Long story short he tightened the bolt up on the steering shaft to steering gear and the steering is tight again, for now. He mentioned that the shaft might be worn...
My steel wavian cans are permanently deformed after one trip from St.Paul MN(600’and 30f) to Sante Fe NM (6000’? And 75).
The stream of gasoline when I stupidly opened the can up sprayed all over me and six foot over my shoulder.
It was actually pretty impressive.
When you install your in bed house bank have it isolated from the starting bank when the engine is off.
If you have a house bank then there should be no need to draw off your starting bank and no need to monitor it.
Save the 712 for your house bank.
We had 2016? taco v6 work trucks for a couple years. Never had a problem with them, didn’t notice any funny trans issues. They burned oil but they idled 24/7.
Not much low end power but what do you expect. I doubt the Colorado with the camaro engine is any different.
I’ve ran a chain through the wheels and through the leaf springs, not too hard.
I had to pickup a boat for my mom once but forgot the key for the coupler lock two hours away. I wanted to just break the lock off and the best option I had on me was a flat tip screwdriver. That lock almost...