The lid is now bolted to the trailer and the struts are installed. The underside of the lid is white and I'm planning to put a bunch of Jeep-related stickers under there so you can see them when the lid is up. The strut mouting brackets are welded at the center point of the lid and about 8 inches from the side of the tub. The struts are 150lb capacity each and as it stands right now the lid will not stay closed. It takes a lot of effort to pull the lid closed and then it immediately pops back open. The lid itself weighs about 125lbs. I've got a Tepui roof top tent that weighs about 100lbs that will be mounted on the lid with a rack. I'm hopeful that the extra weight of the tent and rack will make it easier to close. I've also got to come up with some kind of latch to keep the lid closed. I bought some 3/4" foam weatherstripping on Amazon that I'm planning to put on the perimeter of the underside of the lid to make it a bit more weather resistant. The tailgate is ready to mount. I just need to get the latches mounted and also rig up some kind of drop cable so the tailgate will come down flat which should make it handy as a table, cook surface or whatever. Finally, I still have to get the tongue box mounted up front and then eventually install some electrical gadgets. I'll probably try to use the trailer a few times before I install anything electrical just to get a better feel for what I need and the most convenient place to have phone chargers, lights, etc.