Recent content by Wheelman55

I had 1/2” braided hose collapse on the suction side, so replaced with garden hose. I found these “next level” quick connects recently and used them on an outdoor shower setup. FYI they will not work on the suction side of the system. They work perfectly on the pressure side...

Give these guys a call. They might have a solution for you. https://www.hellroaring.com/ I’ve got two of their dual battery isolators. They’ve been rock solid for me.

X2 on the Deutsch connectors.

You might be able to drive over that edge if you can take it at an angle so only one wheel at a time goes up over the ledge, and use two foot driving. That would be one foot held steady on accelerator pedal, one foot on brake pedal, hold Acc pedal steady at 1200 rpm and use your brake foot to...

I installed tracks in my 2018 Raptor and connect the ARB fridge slide to the tracks with Macs studs. You could install these on top of your bed rug. The write up is here: https://www.fordraptorforum.com/threads/how-to-remove-easy-fuel-filler-cap.62881/#post-1282303

Thanks...nice country. A suggestion - turn off the front pocket lights...would make the viewing more pleasant.

OP. First thing state usage in amp hours and try to report voltages using the same measuring device. If it was me i would choose multi meter. The BB 100ah. I’ve been using this same battery for some years now in my truck to run a fridge. Great battery! A full batt will not accept any more...

As long as you are in there make sure to grease the wheel bearings. It can be a beech sometimes getting to them.

Bummer! Hope that you get it back.

Thule now owns Tepui. Thule has excellent customer service. Try calling them.

If you are USA based. I’ve had very good luck using the Hellroaring isolators. Their isolators are solid state, do not use diodes, have next to zero voltage drop. The company also returns phone calls. Located in Montana. Been building solid state isolators for over 20 years...

Comments for OP. If your bike rack uses a threaded hitch pin, make sure to thread the pin in from the passenger side NOT from driver side. Get the pin nice and tight. If your bike rack is self tightening...get it nice and tight. This should help. Best of luck!

I use the ARB units...however they are a commitment. I like them so much that I’ve installed a second battery in both of my trucks...the total package works really well. The downside is it’s expensive.

If you purchased from an authorized Yakima retailer, and have your receipt, the tent should be covered by Yakima’s lifetime warranty.

I’ve had good results with these glands. However lots of silicone should work:) https://www.heyco.com/Solar_Power_Components/product.cfm?product=Solar-Masthead-II&section=Solar_Power_Components