The custom camper was plenty of work, but this drive train swap is on a whole different level! Ton of fun though :D
I'm keeping the rover axles for now, at least until the next phase of the build when I build a 3-link front & 4-link rear suspension. The LT230 transfer-case will stay too & get...
Bolted down into the body using the original threaded holes that used to be for the rear seats, cargo tie-down loops, seat belt brackets etc. The taller section breaks down into upper & lower halves, you can make out the seam in that carpet at the back there. Each long lower section has 7-8...
I use either a lightweight hiking style air-pad or a nearly twin sized air-foam mattress, both of which roll up & stow away under the bed/bench bifold section. Smaller hiker style one seen here in orange:
My Disco2 project that never ends, I love this truck:
The "camper" setup I built with cabinets & a fold-out bed:
Biggest phase of the project so far, currently swapping in a 4-cylinder Cummins turbo diesel engine & 5-speed manual: