Recent content by The Artisan

Yeah for that much better Kevin

Look for the ARE walkin series. Has door and middle full lift Kevin

Check out my Jeep Jk I installed on my fuso just a little fabrication Kevin

I have a toro 3000, and love it. I use it to sew 346 and 415 theads. The 3200s are a good value Kevin http://artisansew.com/leatherstitchingmachine.html

nice build, does the fridge slide out? Kevin

Love my 03 AC. I plan to remove the bed and replace it with a frp composite pod hard side poptopper. 8 X 5 X 4 pops up to 8. Should only add less than 150lbs once bed is replaced Kevin

One thing also I had polyurea spray machine come in and the crate got flagged. Everyone in that crate had to share the expense of the 2nd inspection and fortuntatly there were like 10 orders in it. Would have sucked if it was just a few Kevin

You could always slant it to get the 2 feet. It could be seating or storage. I am building a hard sided poptopper pod for a client 14 on the floor slanted to 16 over all length. The slant lower will hold his fishing poles exterior and above a full wall of storage for the inside. Kevin

Looks nice does your 19.8k include up to 35% tariffs? Kevin

Great build but you did all the nice carbon and now you are painting it? With all the infusion do you have that many flaws that is noticeable? Seems like a overkill of your time for layers of paint and clear on camper that will get scratched eventually Kevin

This is for s first gen tundra ext cab. The tailgate must be removed. It features a tilt up rear hatch as well as a center entrance door. Locally I was told around 5k to get one installed. $1500.00. It is located in Jefferson Ga Kevin

Sent you a msg Kevin

what do you need done, size and location? Kevin

designed it but never made it. I have all the parts though. Kevin

The shipping cost can get expensive unless that is shipped or you can pick them up. Kevin