Recent content by TactilTex

Thanks to OK4wd for getting my replacement fan out to me so quickly. Now getting the thing off. I removed the three nuts but the adhesive/silicone doesnt want to let loose. Any suggestions? Can I remove the guts from the new fan and install them in the old housing by any chance? That sure...

Appreciate the quick response. Since I bought it from y'all I'll be giving you a call. Anyone in particular I should ask for?

Anyone else have a problem with the solar fan? The things only around five months old and it's dead. I would assume OK4wd would be who I need to contact?

Pro tip: When you wear down the tread and they become slick ...Set the table saw blade at about a 1/16 and add some siping. Like new again as far as traction goes and you double their useful life.

It's cool and all,but the idea of paying $330 bucks so I can sleep under the stars when I have a RTT makes it a no go for me.

Check out RV parts. Maybe someplace like this....http://www.dyersonline.com/

The use of a simple u-joint would solve the problem. It would also allow for more than the 75-83 inch range you have to work with now,which i'm dealing with right now with the telescoping rig i'm building. I'm toying with the idea of making a couple simple u-joints this would allow infinite...

Got the stabilizing jacks installed,the rack for the Evasion is awaiting paint,and the telescoping awning brackets are nearing completion. Pondering the possibilities of closing in the box,maybe some drawers,of course a table. Got a feeling it'll be a work in progress for a few years...

I dont think you're getting what I was asking. I needed to know the location of the the track on the lower shell from front to back so I would know where to place my cross members. In other words I wanted to use as much of the track length as possible to get a wider load dispersion. It's...

Appreciate it. I just about ordered some 4 inch wide,glad I waited. Thanks again.

Anyone know the full width of the extrusion with the mounting slots? Want to purchase some aluminum flat bar for a bracket and it needs to be as wide as the extrusion to allow for bolt holes.

Not sure if these pics are going to work...... If they do. As you can see I have the side rails,just need to know the distance between the cross members that attach to em. Repurposing the Padre Island Nat seashore trailer. It used to hold my Yaks,generator,A/C,25 gallons gas,10 gallons...

There'll be three cross members. Looking at the trailer from the side,how far apart do the cross members need to be? Just the outside two,obviously the third one will be centered. And are the grooves on the lower shell centered end to end? Or do I need to offset my cross members?

On the home stretch on the rack for the Evasion. Problem being I dont have a dimension for how far apart my cross members need to be,or the location of the grooves on the lower shell. Obviously I'll want to center it on the rack. Anyone know where I can get the dimensions?

Go to their website and ask for dealers near you. Thats how I did it and got a prompt response.