Recent content by St8ton

SOLD

SOLD AluCab Gen 3.1 RTT with 4th D Solar Panel $3500 for the tent with the 80w 4thD Solar panel. $4900 with Shadow Awning attached. I will not currently sell the awning separately. Tent is currently off the truck and ready to go. Pickup in Salisbury, NC. Message me for additional details if...

No extension cables were used with the way I have them setup. Each one is linked to the next, one dimmer controls them all. I don't want multiple dimmers; I use one location to turn them on/off/dim.

The covers are from a company in Alaska, Top Notch Alaska. https://www.topnotchak.com/

Added a few goodies to the Smartcap. Table Lock covers

Power is good, no complaints here. Mpg’s are 9-11 around town and 11-14 on interstate In the configuration currently shown below.

Buy the kit I posted above, it has a dimmer built in. And post this kind of stuff in general lighting forum, not my build page.

The current latch design only allows for locking outside of the cap. You could get a buddy to lock you in. ;) And my latches haven't frozen. But I also keep them lubricated, which likely helps...and I live in the south.

It does have some taper back to front, but nothing out of the ordinary. The Cap window does align with the rear mounted cab cargo light and camera. It will illuminate the inside of the cap, and the camera will allow you to view cargo while moving. Hope that helps.

I'm using these currently. https://hardkorr.com/us/product/48cm-tri-colour-led-light-bar-kit-with-diffuser/

If you can find an accurate response from anyone else I’d gladly like to hear (read) it. I will tell you…My Cap is for a 1500 and fits just fine. I did have to get different bed clamps as I was told the factory provided clamps would not work. I did not get to confirm this issue. I was told that...

Yes, that's correct. Each light is connected to the next, one controller.

Nah, no boot. It's just a tight fit and I've got some cables running down in between for solar and lighting that may be blocking some light.