Have you checked your wheel bearings, especially the inside ones? Had mine fail but didnt make any noise. Just suddenly would get a massive shaking at about 60mph.
You very well could have a strut failing causing a funky bounce as the weight shifts around.
Thats pretty freaking sweet dude! (Total 90s flashback)
Honestly, even deciding to just sell the plans, or fair license them would be awesome. (If fair license is the term I'm looking for. Something along the lines of; Here are the plans. You may use them to build your own. But not for profit...
I went to the local 4 Wheel Parts "Beat the Heat" today. I won $125 in gift cards and a SmittyBilt 2780 air compressor. Which I plan to hard mount and remote mount a air tank. Just need to wire it up.
I would like to wire it as a relayed on off. Just have to figure out how to wire that. I am...
Just a few updates.
Installed extended rear brake line. 25" vs stock 15" so I dont break it. Also put in rear 1" spacers to move level out the truck.
Next up on the list is rebuilding the CVs with better boots and brakes.
Also will be installing my CB soon.
My front skid is made from 1/4" aluminum. Works great. Many others use the same one. No issues that I've seen. I made a center skid out of some 1/8" diamond plate aluminum. Not great for sliding across rocks. But the one time I high centered on a rock it did its job. For that I am grateful...
Not sure which trails. Probably the green and blue for goneMoab next year.
Plus the whole 5500miles round trip there and back. So I'm thinking a AT tire. But would want to move to a higher load range. The advantage I have is that I can take the tri spoke 16 off my 99 to use on my 04.
I'd say the IronMan are softer. But both ride very good if not better than stock.
The OME ride more truck like. The IronMan are firmer than stock but ride smoothly. Hard to describe. Right now it looks like the rear of the 99 sits higher. But need to get them side by side.
The 04 is...
The angle and that parking area. If you put a level on the body lines. They are spot on level.
Looks off I know. Probably because the front arch opening are naturally higher than the rears.
Was thinking of adding a spacer on rear to make it more natural looking.
Sent from fat fingers on S6