Recent content by Offroadmuch

https://orangecounty.craigslist.org/cto/d/costa-mesa-2003-mitsubishi-montero/6843323020.html $1000

Reduced to $1000.00 runs, no theottle response. Will need a tow. Buyer to pay for smog.

Reduced: $2500.00 Runs, no throttle response. https://orangecounty.craigslist.org/cto/d/costa-mesa-2003-mitsubishi-montero/6843323020.html

$2500.00 https://orangecounty.craigslist.org/cto/d/costa-mesa-2003-mitsubishi-montero/6843323020.html

https://orangecounty.craigslist.org/cto/d/costa-mesa-2003-mitsubishi-montero/6843323020.html $3500.00

Mine: https://orangecounty.craigslist.org/cto/d/costa-mesa-2003-mitsubishi-montero/6843323020.html

Re About 175,000. Let me check and I will get the actual miles. Timing belt was done at 143,000.

Report from the dealer: It is throwing 30 codes, many inter-related. Cracked exhaust manifolds on both sides, “needs a new intake manifold” possibly EGR valve, O2 sensor and mass air flow sensor. I suspect it is hard to tell since some of these parts effect downstream performance and sensors...

He said the part is almost impossible to find

Hello All, My idle is very rough and getting worse. Will barely run, spuuters and dies. Disconnected the wire to the MAF sensor and it runs perfectly. Service guy at the dealer says it is the throttle body assembly. What do you guys think?

Mine is almost undrivable now. RPM’s want to stay low and then it stalls. If I push the gas and brake I can get it up to a drivable speed. I am going to buy a Denso fuel pump and Mitsubishi fuel filter assembly a nd take it to my guy. I will get codes read and his opinion and go from there.

I have not had codes read at this point. Will get that before doing the fuel pump, filter and lines..

Hello All, I have been away for a while, not spending time on ExPo. Recently my 2003, 3.8L Monty has developed a significant sputter. Maybe starving for fuel? It happens frequently and intermittently, especially after sitting for a day or two. After more driving is goes away almost completely. I...

Is this the fix? I have to go under and see if mine is loose or damaged....

Thanks for the input. Do you recall the part number for the motor. Some of these parts are getting hard to find...