Recent content by Kraxler

Here is the info from Amazon on the fron water tanks. .Recpro RV water Tank 10 gal. I have not installed a water heater yet. There is one filler mounted on the driver side next to my relocated front storage box. The vent for the tanks is up through the generator compartment over to the...

Here are some photos. I actually have 3 tanks mounted. A 9 gal between the axle and 2 10 gal further forward.

I installed the tank between the swing arms, vertically. That is the long side down the trailer length then the next side vertically. Welded on 4 vertically posts with a metal plate on the bottom.

I installed a 9 gal water tank that I got from Amazon. Valterra R8018 8" x 16" x 18" ABS Water Tank

It won’t let me add ore photos. Says they are too large.

Did a small 4 day trip through the Hemes mountains, Santa Fe national forest and the TAOS ski valley.

Just saw that the Habitat off road water tank is available for pre order. $999 for he tank with skid plate. You can also get it with pump and faucet.

Sorry to see you go. Although I’m thinking of selling for the same reasons. Climbing up and down the ladder multiple times at night is getting harder for the wife.

Moment arm. The heavy awning far out from the upright overloaded the welds. May be bad welds or just over their design. I mounted my awning right at the end of the 90, less moment arm.

Looks like Habitat will be coming out with their water tank solution for the trailer shortly. At least there is a drawing of it and saying that pre orders will be taken soon.

Here are some photos. the white tanks from Amazon: RecPro RV Water Tank | Gray Water Tank | RV Fresh Water Tank | Camper | Trailer (10 Gallon) And the black: Valterra R8018 8" x 16" x 18" ABS Water Tank

I have 29 gallon of water mounted in three tanks on the bottom of the trailer. The 9 gallon tank is mounted between the suspension swing arms. Each of he 10 gallon tank is mounted below the front side compartments. I mounted the on demand water pump above he driver side swing arm. Ran a hose...

I drilled my mount to be able to bolt the two together.

I just purchased some screws that matched the supplied ones. In reality I don't think you need more. The factory ones in the original rails should be enough. The extra rails are primarily there to support and keep the RTT from warping. Along with the extra rails I got extra U brackets to...

Extra bracing never hurts. I got 4 extra from Smittybuilt so I have a total of 8 holding my XL RTT. So far no sagging issues.