Man what a project! My only suggestion is a Magnetic knife holder in a moving van is a terrible idea! I assume you'll only put knives there when you are stopped?
As for the Starlink have you considered a 12v swap?
On your B3 setting did you have to crank the torsion bars a bunch with the tool just to get the bolts and blocks started on the b3 setting? I tried to get them in on that and I felt like there was waay to much tension on the torsion bars. I put them on the B2 setting which I feel like was pretty...
Hey all. I have finally finished my conversion. I took some photos to help others along the way . I used this thread for some of it https://expeditionportal.com/forum/threads/chevrolet-express-van-awd-to-4x4-conversion.52911/
But I did a few things differently .
The donor vehicle was 2003...
I am in the final stages of this swap. I used an np241 LD case from a 1500 pickup. I got custom shafts made as the front needed to be shorter and the rear longer. Front shaft does not extend or contract so one length is good. I can get shaft lengths if you like but they may be different...
Looking for AWD Cargo van with ideally Barn doors. less than 240,000kms
Anywhere in Canada and will entertain Stuff in the USA
Budget 10-17k Canadian
No Safaris/Astro vans