Recent content by jethro5

What axles are you using? Are you going to push the rear axles back at all? Love this and thanks for the update! I need to start one myself... Sent from my iPhone using Tapatalk

I’d second the IE Rovers. Sent from my iPhone using Tapatalk

Check out Ashcroft doom the UK, they offer some mods to stiffen but if you are just using for moderate off-road and on road you buy their seal kit. Biggest part is removing it to work on it. Sent from my iPhone using Tapatalk

Exactly, you can do a 17 if you want to source the brake setup from Australia and run smaller calipers. You can run a 32 ish with not any problems on stock diameter. Anything wider or taller and you will need to trim lift and even both. The 17 and 18 wheel options just allow you to air down...

I’m looking for one to build up, how have you set yours up? Sent from my iPhone using Tapatalk

Love these! Was it for sale or just out from the winter thaw? Sent from my iPhone using Tapatalk

Would love to build one day on HD axles and run 40s for a rock crawler rig. Looking forward to seeing how yours evolves. Sent from my iPhone using Tapatalk

Question for you on the lockers, when you engage the compressor and then the rear switch do you hear anything? So it’s common for the solenoid to go out. Depending on it’s wired but most arb are wired so that the front only work when the rear is engaged. So a bad solenoid could prevent both...

Great Basin rovers is a great place to go and they are in SLC. Bill will have you sorted in no time! Sent from my iPhone using Tapatalk

He does build amazing things... last time I ran into him he was starting a project for new chassis to sell. Like to build a 109 with his specs for the Rubicon. Sent from my iPhone using Tapatalk

Pre 1975 and you are good...I'm still looking for one to build some day... Sent from my iPhone using Tapatalk

I would think you might have an issue with the gears or the splines on the half shafts being bent. Look pulling the other side and how that goes. Sent from my iPhone using Tapatalk

Scully off road in the Sacramento area has built a few for friends and is doing some really cool builds currently. He's on Instagram and I can put you guys in contact too. Sent from my iPhone using Tapatalk

It does do those as well per the videos Atlantic British has released. It also does things previously one needed test book to do on our beloved D1s like reset the ECU for hunting idel and give readouts on srs and abs errors and reset them too. That's why I'm really interested! [emoji16] Sent...

Anyone using the iLand tool yet? It's comparable but less expensive and can be used on a family of rovers so expands beyond a specific Vin. Contemplating purchasing one... Sent from my Nexus 5X using Tapatalk