Recent content by Hoefler

Thank you. I am particular to the combination of metal and wood!

I went with the CR130 Cruise. To do it over I would get the elegance with the power saver option. Pete

Slowly starting to look like a camper. We have made the furniture modular. Here we have a kitchen module that contains the fridge, sink and stove. The space underneath this module is reserved for outdoor kitchen stuff. Pete

Thank you. Will have this one in Flagstaff this spring. Pete

Right now they are not. The tanks are 5" tall. The frame they are in is 6" tall, leaving 1" for insulation at bottom of tanks. I have an Espar hydronic water heater. There is enough room to run the pipping along side the tanks or in a wirsbo array to keep tanks and floor warm. The Espar is a low...

Thanks for commenting. We too have experienced the heat that comes of big invertors. We have an aluminum front vent for the cabinet-a source for fresh air to come into electrical box. We are forcing air with small fams. The hot air exhausts up a "chimney" in an effort to duct warm air up. We are...

I have another camper under construction. I have done this one with nearly 150 gallons water capacity in floor-100/50 fresh/gray in an effort to get center of gravity as low as possible. Tanks are constructed of 304 stainless steel and mounted on rubber isolators. I have also lightened the frame...

Send me your email address and I will follow up with info. My email is: pete@camperlogic.com

We have made an integral ISO style hold down in each corner. Works with holding camper down. Fittings can be added when truck is without camper and in utility mode. Pete

Just finished and delivered a Tray Pak for a customer out east. We have incorporated the stile rails into the actual tray for a low profile. Tray sits as low as possible on truck frame and includes a rear drawer for things like shovels and jacks. We loaded an S280 military enclosure on it for a...

I happen to have a pair of those Honda gennys. In answer to your question, we can build for those. I would add vents for heat and air flow. Further, we could make a hold down that mates to the feet on the gennys. In this way, a rear vent could be located to allow for exhaust gas exit. We can do...

Bob, Thinking on a 3 point mount-it point loads the frame of your truck. Imagine put 100,000 pounds on a 3 point mount-the load pushes down on front, and back. The frame pushes back at the leaf spring mounts. Then think on what the weight is doing-its actually bowing the truck frame up. I looked...

Tool boxes We have been very busy. We have our new tray pak in the works are nearly finished with our first unit. We have developed a set of tool boxes that bolt on to any truck body. Boxes are made of aluminum, TIG welded and have a nice seal area. Each box has a bolt on shield for taking on...

We are now an official business with federal tax ID, and a bank account! The company has been incorporated as Camper Logic LLC. We have hired a company to build a proper website and logo. Pete

Thanks for the nice comments. Working hard on getting some weight out of the build and new furniture.