Recent content by Hawk136439

Any plans to make a 6.5ft version for the fullsize crowd? Thinking F150 LongBed

Here's my work in progress from a few hours yesterday. They aren't pretty but not bad for the cost of drawer slides and leftover lumber in the garage. Still need to fold the back seats down so I can build a level surface over them for sleeping.

Looking to sell my ARE cap off my Ranger. It is dark shadow grey and has lifting side windows with screened sliding windows. Comes with factory ARE roof rails and has a Surco aluminum basket attached. This cap is in great condition and allows access to the front of the bed from either side. Only...

.dxf and .dwg of the sheet metal parts would be great!

Not sure if I missed it earlier but what are the dimensions of your trailer? Overall and living space? Also do you have plans to seal up the exterior? I'm not familiar with marine grade plywood so if it is already protected from the elements I apologize. This is some amazing work thanks for...

Did you add any stops or something to keep the drawer from sliding all the way out of truck? Say on a hill?

When you ordered from that site was the price shown per pair or per single slide?

That absolutely helps! Thank you so much!!

Do you have or can you get some close up shots of you rack that wraps around the cap? I would like to build a similar one but don't know how to build the base plates on the bed rails and keep the cap mounting right since it overhangs the bed rails a little bit.

I would love to see some more detailed shots of your rear storage system if you have any?

I must say I love the color! What led headlights did you go with?

YES!!! this would be great!!

Who makes the box on top of the Renegade concept? It doesnt seam to match any of the pelican ones.

Just my thoughts on it: -Guessing it's a drop bracket style kit like what AEV makes for the Ram which makes sense considering what you just paid for the factory suspension. -The bumpers look like they should have been on there from factory instead of the chunked up looking ones chevy threw on...

I built a drop in basket for my Xterra to try and utilize the space between the factory rails while keeping loads as low as possible. It also replaced the factory cross bars with unistrut to allow easier customization. the unistrut is allowed for wider mounting options so we were able to...