Good quality wire ( like the Anchor you chose) and then split loom the entire length. Zip tie every foot or so. If you pass through any holes use grommets.
Run it on top of the frame rail if you can. Much less likely to get damaged there. Especially avoid high heat areas (as others have said).
I've had an ARB Elements fridge/freezer for about 14 months and one day a few weeks ago I went to pre-cool the fridge before leaving on a trip and it wouldn't turn on. No lights on the control panel, no interior LED, no sounds, just dead.
I started trouble shooting by checking the hard wired...
I tried the ARB deflator, but ultimately I went to the Staun’s. I like being able to walk away while they do their business.
I used to verify pressures every time, but they were so reliable, I just trust them now.
Sent from my iPhone using Tapatalk
I’ve got the Astro Pneumatics (1422) and so far it’s been great. I did read about some folks having difficulty with it due to “grit” in the pivot points, so I took mine apart and cleaned/relubed before ever using it.
One other though, if you are going to set any Plusnuts, be sure to get the...
I use a Duel GPS receiver with a non-WIFI) iPad mini and Gaia for primary navigation.
Works great. Acquires faster and holds signal better than my iPhone 11 in trees and canyons.
Also I believe you can connect two different devices via Bluetooth if that is useful in your cabin configuration...
I need a little more storage and would like to add a Leitner ACS rack and some gear pods to my truck. I have a 2020 Nissan Frontier KC SV (6' bed). This should be the same rack for any Frontier 6' 2016-2020. I don't know enough about the Leitner system to know if their racks can be converted to...
Just out of curiosity, can these be modified for shorter bed lengths i.e. 6’1” ? I’ve never seen one up close, but was kinda hoping they were modular and the top tubes could just be cut shorter.
Sent from my iPad using Tapatalk