Recent content by dinobody

  1. D

    UJOR Build Thread

    How do you guys insure your vans? I have a very nice U-joint conversion van and want to make sure that I am covered if anything disastrous happens. Insurance companies are notorious for not paying up if they don't have to.
  2. D

    Van insurance and appraisal info ??

    Who do you guys use for insuring your vans? I have a UJOR low mile ultra clean van. I am interested in a solid stated value policy. Who have you used for appraisals? Thanks Doug
  3. D

    Trailer wiring Ford E350

    I just watched the YouTube video and that pretty much described everything I needed to know and my van had the exact same plug setup
  4. D

    Trailer wiring Ford E350

    I am not sure how to post a pic
  5. D

    Trailer wiring Ford E350

    The four flat was located on the driver's side near the spare tire but it does not have more wires tucked away for the 7. I followed it up the frame rail as far as I could and it still doesn't appear to have what I am told is a blue wire for the trailer brake or a charge wire
  6. D

    Trailer wiring Ford E350

    I have a 2000 E350 with a factory 4 flat plug. I wanna wire a 7 pin plug with brakes. There is a brake controller plug on the driver side kick panel. Though the brake wire ends somewhere in the harness. Anyone have any experience with this? Thanks Doug
  7. D

    UJOR Build Thread

    I am not sure. The van is at the shop getting the tranny done so I cant look. But the van was a shuttle van and it was done buy a company called Com Trans. I will look and see if there is a name when I see it next. All the vans I have seen from them have the same windows you could call them.
  8. D

    UJOR Build Thread

    Thanks!! I am super happy with the way it came out!! It drives amazing. I have had a Advanced Fourwheel Drive Systems 1999 e250 with a 5.4 w/33's. And a Quigley 2003 with a 7.3 w/35's. This van is on 37's and drives fantastic on rough dirt ,groved up pavement and at highway speed. Chris did...
  9. D

    E350 pitman arm removal advice needed

    just went thru this last week. Broke one cheep puller and one snap on puller. Both using a little heat and lots of pb blaster. finaly just took an angle grinder and cut most of the way thru it. Then took a chisle and hit it in the groove I cut then used a puller. It came off easy then.
  10. D

    UJOR Build Thread

    No kidding!!!! I sent many emails and lots of phone calls. No response but you always chime in here Ramsey ******!!!!!! I just sold mine Q van and bought a 2wd and a Ujoint kit . Chris is GREAT at Ujoint!!!
  11. D

    Upgrade the GLASS headlights in your van (not HID, not LED)

    I have the plastic lights on my 2000 e350 and plan on converting to the glass rectangle light. There are no junk yards around here that have a e series vans hard to belive!! I am not exactly sure what all the small parts are but have found the metal back piece and the plastic trim piece. I...
  12. D

    UJOR Build Thread

    How did the r/t 's work in the snow?
Top