Recent content by Copasspupil

No it is just resting there. It has not been secured to the trailer as of yet. To clarify, neither the tent nor the frame are secure at the moment. More for looks than anything. I was trying to figure out where it will go.

Thanks that works for me!!

So I built my trailer and wondering how or if there’s a specific location to adhere the frame to the trailer itself? Does it really matter. I was planning on placing it in the middle of the trailer but now I wondering if it matters centered or more towards the front. My question is more of...

Look great. Don’t worry about the dents or other imperfections, you can see it while driving.

That might work. I could take a section of scrap DOM material weld it to the frame with just an extension on the end then clamp it that way. I’ll go check. Thanks.

Since they really dont sell a mount for it, any ideas for those that have made one or thought of doing it? My RTT frame is set with 1 3/4” DOM tubing and I have to either use a 15” section of the same DOM tubing welded to a piece of flat stock. OR. I use 2x2 square tubing and do the same idea...

Fellow union brother, Recommend that you hold off on the axle until you have finished the frame first before order it. I had to buy an additional axle after having it done and gave the measurements to the trailer shop by me. Buy a 3500 lb axle that fits a Jeep which is what I did and no need for...

Almost finished the welding for the tent frame. Just need to figure out how to attach the batwing cover from rhino

Here’s mine. Working on the tent frame as we speak. I should have it done in the next couple of weeks.

I chose to use just three as well. I looked those too but when I placed my order with etrailer, I just bought their out of convenience.

Like what you’ve done especially your lighting control setup. Heck I even check out where you were in Washington. Keep it up.

I hadn’t gotten that far yet. It was in my to do list. After my rack build for sure.

I’ve never had a problem towing it. The general rule for trailer placement that I found all over the net and I measured like 5x for welding it for a 60/40 split. It an optical illusion when you view it. The measurement is spot on but thanks for the compliment on the trailer.

Nicely done. Keep it up.

Looks like I’m on to stage two of the build: rtt rack. 1.75” 120dom. Adding light mounts for the corners, hi lift mount, looking to make a mount for the Rhino foxwing setup and probably some type of carabiner mount. I’ve got a nice stretch of weather coming this week so hope to have it done by...